There are plenty of products now available to install into your home to keep it secure against intruders. As well as there being plenty of different alarms there is now a larger than ever selection of DIY sets that you can install your self instead of hiring somebody to complete the work for you. So you firstly need to establish the kind of system you are going to install; motion detector, heat sensor or a contact alarm. In many cases its thought a motion detecting alarm is the best one to use, a lot of these systems can also be wireless where as that was a weak point of the older wired alarms as thieves began to learn how to cut the wires and such on this type of alarm.

There are some simple steps you can follow to install your own wireless alarm system, so if you follow these steps you are less likely to need a professional to install it for you:

• The first thing you need to do is decide what is the right kind of system for you, normally because it’s the easiest wireless systems are the best for you to install your self.
• Once you have your system then you need to decide where you will place your control panel its thought best that you fit it in a place that you frequently pass when going in and out of your home, most people put it next to or near their front door, although you need to make sure it is not completely visible to people outside your home as this could act as an opportunity for potential thieves to figure out your system before breaking in.
• You will next have to programme your control panel, the manual the product comes with should show you how to do this step by step, just be sure you know exactly how to do this before carrying it out.
• There are systems that are monitored if tripped and there fore are harder to install than other systems so you may need to have some professional help for this stage as there is certain wiring to the phone line that needs to be correct in order for the system to work and for the alert to got to the right place (usually the local police station).
• You will then need to install and programme your siren this you can normally do with a small screw driver to set the code inside. You will of course have to refer to the instructions for your particular model of alarm to see how this is done correctly.
• After this you will have to install the sensors there are different types of sensor you can have including magnet sensors that usually consist of a transmitter that is attached to the frame of the door or window and a magnet attached to the door or window which when the connection is broken the alarm is set off. Other variations include Passive Infrared Motion Sensors that basically have infrared sensors and when the line is broken by movement the alarm is set off and you can also install broken glass detectors and smoke detectors or even heat sensors to increase the security these are harder to install but you can either follow the instructions that come with the product or get a professional to fit them for you.
• Then all that’s left to do is test your system to make sure everything is working correctly, your control panel should have a test mode you can switch it on to.

There are so many products now that you can fit your self you can install nearly any security product on your own but it is advised you get a professional to check the system over to make sure everything is safe and in working order.